Raceworks 1100cc Flow Matched Port Injectors for BMW B58 S55 S58
| Specifications |
Part Number |
Modified/High Flowed Bosch Injector
Size: 1100cc ( 105 Lb/hr) @ 3bar and 1300cc (124 Lb/hr) @ 4bar.
Impedance: High (12 Ohms)
Plug: USCAR. Top O-Ring: 14mm. Bottom O-Ring: 14mm and 15mm included (For LS Applications)
Ethanol & Methanol Safe
Spray Pattern โ Narrow Cone
Spray Direction โ Straight
Flow variance is +/- 1.5% (3% Total) |
INJ-500 |
Download Injector Calibration Data PDF
Download Injectors Size Charts PDF
*Injectors are a direct fit physically, but as with all Raceworks Injectors, will require a tune. While the vehicles listed above are direct fit, the injector can be used in many other applications with the appropriate extensions, o-rings or plug adapters. Seeย Injector Upgrade Guideย for more details.
FLYWHEEL POWER FIGURES (ESTIMATED) PER INJECTOR
| Normally Aspirated Gasoline |
220HP |
165KW |
| Forced Inducted Low Boost Gasoline |
180HP |
135KW |
| Forced Inducted High Boost Gasoline |
195HP |
145KW |
|
|
|
| Normally Aspirated E85 |
165HP |
125KW |
| Forced Inducted Low Boost E85 |
130HP |
95KW |
| Forced Inducted High Boost E85 |
140HP |
105KW |
MODIFIED INJECTORS
This is done for increased flow.
Various organisations commonly do this by โde-cappingโ the injectors. Almost all Bosch EV14 injectors have a cap on the nozzle that is laser welded. This cap controls flow, assisting Bosch in reducing flow variance, and determines spray pattern. A nozzle may have multiple holes drilled on precise angles, to give desired spray pattern, commonly a cone with a particular spray width and angle. By removing this the flow of the injector is significantly increased, which leads to a larger flow variance and reduction in the quality of the spray pattern.
Raceworks injectors are de-capped but are taken one step further, and the remaining single hole/pintle is precisely drilled to restore the spray pattern quality and width.
All Raceworks injectors are statically and dynamically flow matched. This is done to accurately replicate their operating conditions in a vehicle. The n-Heptane test fluid is temperature controlled, and the injectors are preconditioned with 10,000 pulses, before being statically flowed at 3 different fuel pressures. They are then dynamically flowed at the same 3 fuel pressures, but with 25 different pulse widths. The injectors are also flowed at 10 different voltages, from 6V-15V respectively. What is most important is the set of injectors arenโt pulsed at the same time, as is the case with many inferior Injector Flow Benches. Pulsing at the same time causes a pressure differential through the rail and isnโt an accurate representation of their true firing order.
